Why Does My Garage Door Track To One Side

This usually happens when the bolts holding the horizontal tracks get loose causing the bracket to wobble at the slightest unnatural vibrations of the door.

Why does my garage door track to one side.

One of the more difficult problems for do it yourselfers to diagnose is a worn cable pulley on an extension spring door. The track should be tighter at the bottom then at the top if it is tight enough at the bottom the door will always close in the same position. Your door has simply shifted to one side. The vertical tracks should be in a slight v instead of being plumb up down.

I have no overhead garage door one third horsepower. Click on a problem below to see the possible causes and solutions. The cable is attached to the door and runs to an s hook that attaches to the track support. The front measured 15 and the back measured 16 from the wall.

With misaligned tracks the risk of the rollers coming off the tracks gets much higher. By pushing the door back into position you should have made the vertical track straighten. Bent tracks on your garage door need immediate repair to get the door working properly. Most track damage happens to the vertical tracks that attach to the wall of the garage door opening.

Bottom of the door is up on one side. Or it could just be that the hardware has become loose over time. Garage door shifts to one side. Yeah that was it.

There are of course many other problems that can keep your garage door from functioning properly. I had a garage door company here that told me my garage door needs to be balanced and showed me how it would not stay up by itself when door is not engaged. Maybe someone bumped into it recently. Move the bottom of the track on the right closer to the door so it can t shift back.

With the door propped open take the s hook out of the support and tighten or loosen the cable as needed. The door runs are housed in a garage door track one on each side of the garage door. Thanks for the quick response. It is possible that the vertical track down the side has gone out of alignment and shifted due to a slightly loose lag screw.

Push the door back to adjust the door and get the center aligned again. Changed them to be the same and now the cables are equal and the track isn t hitting the door.